Replacing The Knee Angle Assembly (Complete); Replacing The Footplate Adapter - Otto Bock kimba neo Service Manual

Service Work
Replacing the Flange Nut on a Slider
1) Loosen the mounting screws in the sliders (see Fig. 97, Pos. 1).
2) Remove the inserted flange nuts (see Fig. 97, Pos. 2) from the sliders and replace them.
3) Secure the flange nuts with the mounting screws.

3.6.3.3 Replacing the Knee Angle Assembly (Complete)

1) Remove the seating unit from the outdoor mobility base.
2) Loosen the 2 x knurled nuts on the underside of the base frame (see Fig. 99, Pos. 1).
3) If required: Loosen the 2 x knurled nuts on the rear mounting screws on the hip supports (see Fig. 111).
4) Pull the knee angle assembly (complete) out of the base frame and replace it (see Fig. 100).
5) Remove the footplate from the footplate adapter (see Page 31).
6) Slide the knee angle assembly (complete) back into the base frame and mount it.
7) Slide the footplate onto the footplate adapter (see Page 31).
8) Hand-tighten the knurled nuts.

3.6.3.4 Replacing the Footplate Adapter

1) Remove the footplate (see Page 31).
2) Remove the knee angle assembly from the base frame (see Page 32).
3) Loosen the pivoted levers (see Fig. 101, Pos. 1) from the end pieces of the "seat adjuster" (see Fig. 101,
Pos. 2).
4) Open the clamping lever (see Fig. 101, Pos. 3) and pull the footplate adapter (5see Fig. 101, Pos. 4) from the
struts (see Fig. 101, Pos. 5).
5) Pull the struts from the end pieces of the "seat adjuster" (see Fig. 101, Pos. 5/2).
6) Prepare the new footplate adapter (see Fig. 102).
7) Insert the struts into the end pieces of the "seat adjuster" (see Fig. 102, Pos. 1).
8) Slide the footplate adapter onto the struts (see Fig. 102, Pos. 2).
9) Engage the clamping lever (see Fig. 102, Pos. 3).
10) Mount the pivoted levers (see Fig. 102, Pos. 4) on the end pieces of the "seat adjuster" with the mounting
screws (see Fig. 101, Pos. 1/2).
32 | Ottobock
98
99 100
Kimba neo