Replacing The Thoracic Supports; Replacing The Hip Supports - Otto Bock kimba neo Service Manual

3.6.5.2 Replacing the Thoracic Supports

1) Open the zipper at the top of the pad (see Fig. 70) and fold the backrest pad forward.
2) Loosen the knurled nuts on the back of the back plate (no illustration).
3) Remove the mounting screws and supports.
4) Remove the covers from the supports (see Page 24) and replace the supports.
5) Pull the covers over the new supports with proper alignment (see Page 24).
6) Preinstall the supports on the correct sides with the mounting materials provided (see Fig. 109).
7) Put the mounting screws through the slotted holes in the support and the slotted holes in the back frame/back
insert, respectively (see Fig. 110, Pos. 1).
8) Fasten the thoracic supports on the back of the back insert using knurled nuts. If necessary, adjust the
width/height.
9) Hand-tighten the knurled nuts.
10) Fold the backrest pad back over the supports and close the zipper.

3.6.5.3 Replacing the Hip Supports

1) Remove the seat pad (see Fig. 70).
Kimba neo
106
108
109
Service Work
107
110
Ottobock | 35