Replacing The Lateral Supports - Otto Bock kimba neo Service Manual

Service Work
2) Remove the covers from the supports (see Page 24).
3) Loosen the 4 x knurled nuts on the underside of the seat (see Fig. 103, Pos. 1).
4) Remove the mounting screws and supports.
5) Preinstall the supports on the correct sides with the mounting materials provided (see Fig. 112).
6) Put the mounting screws through the slotted holes in the support and the slotted holes in the base frame (seat
frame) and the front seat plate, respectively (see Fig. 113).
7) Mount the hip supports on the underside of the seat using knurled nuts (see Fig. 103, Pos. 1).
8) Adjust the seat width by moving the hip supports (see Fig. 113). This also allows for abducted settings. Hand-
tighten the knurled nuts.
9) Adjust the depth of the supports if required (see Fig. 114). Tighten the mounting screws.
10) Pull the covers over the supports with proper alignment (see Page 24).
11) Replace the seat pad and secure it with the hook-and-loop fastener (see Fig. 70).

3.6.5.4 Replacing the Lateral Supports

1) Open the zipper at the top of the pad (see Fig. 70) and remove the backrest pad (see Page 24).
2) Remove the covers from the supports (see Page 24).
3) Remove the back insert (see Page 26).
4) Remove and set aside the back frame (see Page 29).
5) Remove the back plate from the back frame:
→ Using a spiral bit (Ø 5 mm), bore out 4 rivets between the back frame and back plate (see Fig. 115, Pos. 1)
and tap them out with a pin punch (Ø 3 mm).
→ Remove the 4 x Phillips screws between the back frame and back plate (see Fig. 115, Pos. 2)
→ Remove the 2 x set screws from the tube clamp (see Fig. 116, Pos. 1).
→ Remove the knob (see Fig. 85, Pos. 1) and the mounting screw (see Fig. 85, Pos. 2) from the clamp tie-bar
(see Fig. 85, Pos. 3).
→ Pull the back plate off the back frame.
6) Pull the tubes of the back frame (see Fig. 116, Pos. 2) from the lateral pads (see Fig. 116, Pos. 3) and the
plastic slides of the clamp tie-bar (see Fig. 116, Pos. 4).
7) Replace the lateral supports (see Fig. 118).
36 | Ottobock
111
113
112
114
Kimba neo