Replacing/Retrofitting The Tip-Assist; Retrofitting The Respirator Platform - Otto Bock kimba neo Service Manual

3.5.7.2 Replacing/Retrofitting the Tip-Assist

1) Install the tip-assist on the lashing point at the rear with 2 mounting screws (see Fig. 53, item 1).
2) Firmly tighten the cap nuts (see Fig. 54, item 1).

3.5.7.3 Retrofitting the Respirator Platform

WARNING
Use in a wheelchair accessible vehicle is forbidden
Severe injury in case of accidents
► Use of the product in wheelchair accessible vehicles in combination with the artificial respiration platform
option is not permitted.
INFORMATION
The respiration platform cannot be used on a product with fixed front wheels.
Mounting instructions
• The option can be installed as follows:
– Installation of the large plate over the front wheels (see Fig. 55) – user sits in the seat facing opposite to the
direction of travel
– Installation of the large plate over the rear wheels (see Fig. 56) – user sits in the seat facing in the direction
of travel
• Using an anti-slip mat is recommended.
Turning the seating unit is only possible if the respirator platform installation is changed.
•
• The respirator is attached to the respirator platform using straps through the slots.
Kimba neo
51
53
Service Work
52
54
Ottobock | 21