Replacing The Backrest Pad; Replacing The Covers - Otto Bock kimba neo Service Manual

Service Work

3.6.1.2 Replacing the Backrest Pad

INFORMATION
The manufacturer offers two versions of the backrest pad:
► Back pad for standard back insert (see Fig. 67)
► Back pad for back insert with head supports (see Fig. 68; to adjust the clearance of the integrated head sup­
port: see Page 26)
1) Release the twist lock of the backrest pad behind the seat bottom (see Fig. 69).
2) Unzip the backrest pad zipper (see Fig. 70) and remove/replace the backrest pad.
3) Put the backrest pad in place and pull it through between the back and seat bottom.
4) Close the twist lock (see Fig. 69).
5) Slide the backrest pad under the lateral supports (no illustration).

3.6.1.3 Replacing the Covers

INFORMATION
The manufacturer offers the covers in the following versions:
► Covers for headrest supports (see Fig. 71, Pos. 1)
► Covers for lateral supports (see Fig. 71, Pos. 2)
► Covers for thoracic supports (no illustration)
► Cover for the grab rail (see Fig. 71, Pos. 3; see the following section for replacement)
► Covers for hip supports (see Fig. 71, Pos. 4)
► Cover for the abductor (see Fig. 71, Pos. 5)
1) Remove the seat pad or backrest pad if required.
2) Open the hook-and-loop closure on the cover.
3) Remove the cover from the support or abductor and replace it.
4) Slide the cover over the support with proper alignment. Note the following:
→ If present: position the side reinforced with foam material on the outside (over the screw heads) (see
Fig. 72, Pos. 1).
24 | Ottobock
67
69
68
70
Kimba neo