Replacing The Lateral Supports; Replacing The Headrest Supports; Installing/Removing The Seat Depth Reducer - Otto Bock kimba neo Service Manual

Service Work

3.6.2.5 Replacing the Lateral Supports

To install the lateral supports: see Page 36.

3.6.2.6 Replacing the Headrest Supports

To install the headrest supports: see Page 34.

3.6.2.7 Installing/removing the seat depth reducer

INFORMATION
The seat depth of the multifunctional seating unit in size 1 can be reduced by 5 cm to 14 cm with the seat depth
reducer.
Installing the seat depth reducer
1) Remove the covers.
2) Remove the hip pads (see Page 35).
3) Remove the back frame. In order to do so, loosen the four mounting screws on the back frame – base frame
connection (see Fig. 90, item 1/2) and remove the four bearing bushings (see Fig. 90, item 3).
4) Attach the seat depth reducer with two mounting screws and two bearing bushings to the base frame (see
Fig. 92, item 1; see Fig. 93, item 1).
INFORMATION: In doing so, secure the mounting screws with a medium-strength liquid thread lock
compound (see Fig. 94).
5) Install the back frame with two mounting screws and two bearing bushings to the seat depth reducers (see
Fig. 92, item 2; see Fig. 93, item 2).
INFORMATION: In doing so, secure the mounting screws with a medium-strength liquid thread lock
compound (see Fig. 94).
6) Attach the hip pads and pull over the covers.
Removing the seat depth reducer
1) Remove the covers.
2) Remove the hip pads (see Page 35).
3) Loosen and remove the four mounting screws on each seat depth reducer (see Fig. 92, item 1/2). Remove the
bearing bushings.
→ The back frame is now separated from the base frame.
4) Attach the back frame with the bearing bushings inserted (see Fig. 90, item 3) to the base frame (see Fig. 95,
item 1) using two mounting screws (see Fig. 90, item 1/2).
5) Attach the hip pads and pull over the covers.
30 | Ottobock
90 91
Kimba neo