Options/Accessories; Replacing/Retrofitting Safety Belts And Positioning Systems - Otto Bock kimba neo Service Manual

8) Push the tubes of the back frame (see Fig. 116, Pos. 2) through the lateral supports (see Fig. 116, Pos. 3) and
the plastic slides of the clamp tie-bar (see Fig. 116, Pos. 4) on the back plate.
9) Rivet and screw the back plate in place.
10) Use the mounting screw to install the knob (including back securing bolt: see Fig. 85, Pos. 4) on the clamp tie-
bar.
11) Reinstall the back frame (see Page 29).
12) Install the back insert (see Page 26).
13) Pull the covers over the supports with proper alignment (see Page 24).
14) Reattach and close the backrest pad (see Page 24).

3.6.6 Options/Accessories

3.6.6.1 Replacing/Retrofitting Safety Belts and Positioning Systems

For the installation of the following add-on components, see the Instructions for Use (Qualified Personnel) – order
number 647G771:
• Safety belts:
– Strap guide
– Lap belt
– Four-point belt
– Five-point belt
• Positioning aids:
– Abductor
– Chest and shoulder support
– Fixation vest
– Groin strap
– Hook-and-loop foot straps
– Pelvic band (for installation information, consult the instructions that come with the product)
Kimba neo
115
117
Service Work
116
118
Ottobock | 37