→ During assembly, firmly press the Bowden cable adapter into the adapter on the back plate (see Fig. 86,
Pos. 1/2).
3.6.2.4 Replacing the Back Frame (Complete)
1) Remove the backrest pad (see Page 24).
2) Remove the back insert (see Page 26).
3) Remove the tilt activation mechanism (see Page 28).
4) Loosen the 4 x mounting screws on the back frame-base frame connection (see Fig. 90, Pos. 1/2).
5) Remove the 4 x bearing bushings (see Fig. 90, Pos. 3).
6) Separate the back frame from the base frame and replace it.
7) Install the back frame using the mounting materials provided (see Fig. 91).
8) Tighten the mounting screws.
INFORMATION: Tighten the screw connections so that there is no play between the mounting ele
ments. Take care, however, not to deform any components. Then check the movability of the connec
ted frame components and readjust the tightness of the screw connections as necessary.
9) Reinstall the tilt activation mechanism (see Page 28) and the back insert (see Page 26).
10) Reinstall the backrest pad (see Page 24).
Kimba neo
86
88
Service Work
87
89
Ottobock | 29