Preventive Maintenance; Controller; Inspection Plan, Safety Functions - Universal Robots ur3 Original Instructions Manual

2. Preventive Maintenance

2.1 Controller

2.1.1 Inspection plan, Safety Functions

The safety functions of the robots must be tested at least once a year to ensure correct function. The
following tests must be performed.

Test that the Emergency Stop button on the Teach Pendant functions:
o Press the Emergency Stop button on the Teach Pendant
o Observe that the robot stops and turns off the power to the joints
o Power the robot again

Test Free drive mode:
o Set the robot in Free drive mode by pressing the Free drive button on the Teach Pendant
o Move the robot to a position where it is stretched out horizontally
o Monitor that the robot maintains its position when not holding the robot and the Free
drive button still pressed.

Test Back drive mode:
o If robot is close to collision, the BACKDRIVE function can be used to move robot arm to safe
position before initializing.
o Press ON to enable power for the joints - Do NOT release the brakes.
o Press and hold Freedrive -> status will change to BACKDRIVE
o Pull joint away from collision area -> brake is released for only this joint as long as freedrive
is pressed.

Verify safety settings:
o Verify that the safety settings of the robot comply with the Risk Assessment of the robot
installation

Test that additional safety inputs and outputs are still functioning:
o Check which safety inputs and outputs are active and test that they can be triggered.
All rights reserved 6 Servicemanual_UR3_en_rev3.1.2