Checking The Brake Fluid Level - Yamaha FJR1300AS(X) Service Manual

air must be removed by bleeding the brake
system. Air in the brake system will consid-
erably reduce braking performance.
ECA13510
CAUTION:
After adjusting the brake pedal position,
make sure there is no brake drag.
L LLL L LLL L L LLL L
3. Adjust:
• Rear brake light switch
Refer to "ADJUSTING THE REAR BRAKE
LIGHT SWITCH" on page 3-30.
EAS21240

CHECKING THE BRAKE FLUID LEVEL

1. Stand the vehicle on a level surface.
NOTE:
• Place the vehicle on the centerstand.
• Make sure the vehicle is upright.
2. Remove:
• Right side cover
Refer to "GENERAL CHASSIS" on page 4-1.
3. Check:
• Brake fluid level
Below the minimum level mark "a" → Add the
recommended brake fluid to the proper level.
Front brake
Recommended fluid
DOT 4
Rear brake
Recommended fluid
DOT 4
L LLL L L LLL L L LLL L LLL
A. Front brake
B. Rear brake
EWA13090
WARNING
• Use only the designated brake fluid. Other
brake fluids may cause the rubber seals to
deteriorate, causing leakage and poor
brake performance.
• Refill with the same type of brake fluid that
is already in the system. Mixing brake fluids
may result in a harmful chemical reaction,
leading to poor brake performance.
• When refilling, be careful that water does
not enter the brake fluid reservoir. Water
will significantly lower the boiling point of
the brake fluid and could cause vapor lock.
ECA13540
CAUTION:
Brake fluid may damage painted surfaces
and plastic parts. Therefore, always clean up
any spilt brake fluid immediately.
NOTE:
In order to ensure a correct reading of the brake
fluid level, make sure the top of the brake fluid
reservoir is horizontal.
4. Install:
• Right side cover
Refer to "GENERAL CHASSIS" on page 4-1.
3-29
CHASSIS