Adjusting The Shift Pedal (Fjr1300A); Adjusting The Shift Pedal (Fjr1300As) - Yamaha FJR1300AS(X) Service Manual

EC3P61029
CAUTION:
Make sure that the main switch is turned to
"OFF" before checking the operation of the
hydraulic unit.
k. After operating the ABS, repeat steps (e) to
(i), and then fill the brake master cylinder res-
ervoir or brake fluid reservoir to the proper
level with the recommended brake fluid.
l. Tighten the bleed screw to the specified
torque.
Brake caliper bleed screw
6 Nm (0.6 m·kg, 4.3 ft·lb)
m. Fill the brake master cylinder reservoir or
brake fluid reservoir to the proper level with
the recommended brake fluid.
Refer to "CHECKING THE BRAKE FLUID
LEVEL" on page 3-29.
EWA14020
WARNING
After bleeding the ABS, check the brake op-
eration.
L LLL L LLL L L LLL L
EAS21380

ADJUSTING THE SHIFT PEDAL (FJR1300A)

1. Check:
• Shift pedal position
Check that the center of the shift pedal end
"1" is aligned with the center of the middle
gear case cover bolt "2" as shown in the illus-
tration when viewed directly from the side.
Incorrect → Adjust.
2. Adjust:
• Shift pedal position
M MMM M MMM M M MMM M
a. Loosen both locknuts "1".
b. Turn the shift rod "2" in direction "a" or "b" to
obtain the correct shift pedal position.
L LLL L L LLL L L LLL L
M MMM M M MMM M M MMM M
Direction "a"
Shift pedal is raised.
Direction "b"
Shift pedal is lowered.
NOTE:
Check that the groove "c" in the shift pedal is be-
tween the projections "d" on the frame.
2
c. Tighten both locknuts to specification.
L LLL L LLL L
LLL
ET3P66029
ADJUSTING THE SHIFT PEDAL
(FJR1300AS)
1. Check:
• Shift pedal position
NOTE:
The shift pedal "1" can be adjusted to three po-
sitions to suit the rider's preference as shown.
2. Adjust:
• Shift pedal position
M MMM M MMM M
MMM
a. Remove the shift pedal "1" by removing the
shift pedal bolt "2".
3-32
1
a
b
d
c
Locknut
7 Nm (0.7 m·kg, 5.1 ft·lb)
L LLL L L LLL L L LLL L
M MMM M M MMM M M MMM M
CHASSIS
L LLL L LLL
M MMM M MMM