Yamaha FJR1300AS(X) Service Manual page 251

• Brake pipe (brake pipe/upper joint assembly
to front brake calipers) "3"
• Gaskets New
• Brake pipe union bolts
• Brake hose union bolt
Brake pipe union bolt
30 Nm (3.0 m·kg, 22 ft·lb)
Brake hose union bolt
30 Nm (3.0 m·kg, 22 ft·lb)
NOTE:
When installing the brake hose and brake pipes
onto the brake pipe joint assembly or brake hose
joint assembly, make sure that the brake pipes
touch the projections "a" on the hydraulic unit as-
sembly bracket.
a
2
a
7. Install:
• Proportioning valve "1"
• Brake pipe (hydraulic unit to proportioning
valve) "2"
Proportioning valve bolt
7 Nm (0.7 m·kg, 5.1 ft·lb)
NOTE:
Temporarily install the brake pipe.
8. Tighten:
• Brake pipe flare nuts
Brake pipe flare nut
16 Nm (1.6 m·kg, 11 ft·lb)
ECA3P6D022
CAUTION:
If the brake pipe flare nut does not turn easi-
ly, replace the hydraulic unit, brake pipes,
and related parts as a set.
NOTE:
First tighten the flare nut "3" on the hydraulic unit
assembly end of the brake pipe, then the flare
nut "4" on the proportioning valve end.
ABS (ANTI-LOCK BRAKE SYSTEM)
3
a
1
4-64
4
1
9. Install:
• Brake pipe (proportioning valve to rear brake
hose) "1"
• Brake hose holder "2"
NOTE:
Temporarily tighten the brake pipe flare nuts and
brake hose holder bolt.
10.Tighten:
• Brake pipe flare nuts "3"
• Brake hose holder bolt "4"
Brake pipe flare nut
16 Nm (1.6 m·kg, 11 ft·lb)
Brake hose holder bolt
7 Nm (0.7 m·kg, 5.1 ft·lb)
ECA3P6D022
CAUTION:
If the brake pipe flare nut does not turn easi-
ly, replace the hydraulic unit, brake pipes,
and related parts as a set.
NOTE:
• First tighten the brake pipe flare nut, then the
brake hose holder bolt.
• Make sure that the brake pipe is parallel to the
proportioning valve as shown in the illustration.
• Do not bend the brake pipe when tightening
the brake pipe flare nuts.
1
3
2
2
3
4