Yamaha FJR1300AS(X) Service Manual page 442

c
e
L LLL L LLL L L LLL L
4. Install:
• Rear balancer lever "1"
• Rear balancer lever bolt "2"
NOTE:
• Apply locking agent (LOCTITE
of the balancer lever bolt.
• Temporarily tighten the balancer lever bolt.
2
5. Tighten:
• Rear balancer shaft "1"
Rear balancer shaft
0.4 Nm (0.04 m·kg, 0.29 ft·lb)
NOTE:
Tighten the balancer shaft to the specified
torque by turning it counterclockwise, and then
turn it two marks back on the balancer lever
scale.
6. Tighten:
• Rear balancer lever bolt "1"
f
L LLL L L LLL L L LLL L
®
) to the threads
1
1
• Rear balancer shaft pinch bolt "2"
NOTE:
Make sure that the balancer shaft does not ro-
tate.
LLL
7. Start the engine and check that there is no
abnormal noise coming from the balancer
gear. If noise is abnormal, adjust the gear
lash by turning the balancer shaft.
NOTE:
With each adjustment, turn the balancer shaft
one scale.
Clockwise
Counterclockwise
5-137
BALANCERS
Rear balancer lever bolt
14 Nm (1.4 m·kg, 10 ft·lb)
Rear balancer shaft pinch bolt
10 Nm (1.0 m·kg, 7.2 ft·lb)
1
2
Gear lash decreased
Gear lash increased