Checking The Vehicle After Bleeding The Hydraulic Clutch System (Fjr1300As Only) - Yamaha FJR1300AS(X) Service Manual

e. Disengage the clutch by turning the manual
clutch operation bolt.
f. Measure the clutch pressure plate stroke.
Clutch pressure plate stroke
FJR1300AS 2.8 mm (0.11 in) or
more
g. If the pressure plate stroke is out of specifica-
tion, repeat steps (j) to (l) in the procedure for
step "2. Bleed" until clutch pressure plate
stroke is within specification.
L LLL L LLL L L LLL L
4. Install:
• Swingarm
Refer to "SWINGARM" on page 4-96.
• Rear wheel
Refer to "REAR WHEEL" on page 4-25.
• Air filter case
Refer to "GENERAL CHASSIS" on page 4-1.
ET3P66067
CHECKING THE VEHICLE AFTER
BLEEDING THE HYDRAULIC CLUTCH
SYSTEM (FJR1300AS only)
1. Check:
• Rear wheel drag torque
Rear wheel does not rotate/drag torque does
not progressively increase in the following or-
der: neutral, 1st gear, and when rear wheel
starts to rotate in 1st gear → Check the pres-
sure plate stroke.
Refer to "BLEEDING THE HYDRAULIC
CLUTCH SYSTEM (FJR1300AS)" on page
3-19.
M MMM M MMM M M MMM M
a. Place the vehicle on the centerstand.
b. Turn the main switch to "ON".
c. Shift the transmission into neutral, and then
rotate the rear wheel by hand.
d. Shift the transmission into 1st gear, and then
rotate the rear wheel by hand.
L LLL L LLL L L LLL L
L LLL L L LLL L L LLL L
M MMM M M MMM M M MMM M
L LLL L L LLL L L LLL L
2. Check:
• Shift operation
Engine stalls → Check the pressure plate
stroke.
Refer to "BLEEDING THE HYDRAULIC
CLUTCH SYSTEM (FJR1300AS)" on page
3-19.
M MMM M MMM M
a. Place the vehicle on the centerstand.
b. Start the engine.
c. Shift the transmission from neutral to 1st gear
and back to neutral ten times.
LLL
d. Shift the transmission into 1st gear, and then
apply the rear brake.
NOTE:
If the engine stalls, restart the engine, let it idle
for at least 90 seconds, and then repeat steps (c)
and (d).
L LLL L LLL L
3. Check:
• Starting-off performance of vehicle
Abnormal vehicle vibration/abnormal start-
ing-off performance/sudden acceleration
compared to before the hydraulic clutch sys-
tem was serviced → Select diagnostic code
No. Sh_ _66 in the diagnostic mode and op-
erate the hand shift lever switch (shift up) two
times.
Refer to "Diagnostic code table (Diagnostic
code No. Sh_ _66)".
M MMM M MMM M
a. Place the vehicle on the centerstand.
b. Start the engine and warm it up until at least
three segments appear on the coolant tem-
MMM
perature meter "1" as shown in the illustra-
tion.
c. Shift the transmission into 1st gear, and then
slowly turn the throttle grip and check that the
rear wheel rotates.
d. Check that the transmission can be shifted
into 2nd gear.
LLL
3-21
M MMM M M MMM M M MMM M
L LLL L L LLL L L LLL L
M MMM M M MMM M M MMM M
1
ENGINE
M MMM M MMM
L LLL L LLL
M MMM M MMM