Yamaha FJR1300AS(X) Service Manual page 121

1. Rear wheel sensor lead
2. Brake hose (rear brake master cylinder to brake
pipe/middle joint assembly)
3. Rear brake fluid reservoir hose
4. Rear brake fluid reservoir
5. Brake pipe (hydraulic unit to metering valve)
6. Hydraulic unit assembly
7. Brake pipe (hydraulic unit to proportioning valve)
8. Brake pipe/upper joint assembly
9. Brake pipe/middle joint assembly
10. Brake pipe/lower joint assembly
11. Clutch actuator motor lead
12. Clutch actuator sensor lead
13. Rear brake light switch lead
14. Brake pipe (metering valve to right front brake
caliper)
15. Brake pipe (front brake master cylinder to brake
pipe/lower joint assembly)
16. Brake pipe (brake pipe/upper joint assembly to
front brake calipers)
17. Rear brake light switch
18. Brake hose (brake pipe to rear brake caliper)
A. Route the rear wheel sensor lead to the inside of
the swingarm, making sure that the lead does not
protrude above the swingarm.
– –
B. 45 55 mm (1.77 2.17 in)
– –
C. 20 30 mm (0.79 1.18 in)
D. Fasten the clutch actuator motor lead and clutch
actuator sensor lead with the holder.
E. Fasten the rear brake light switch lead, rear wheel
sensor lead, clutch actuator motor lead, and clutch
actuator sensor lead with the holder.
F. Fasten the brake pipe (brake pipe/upper joint
assembly to front brake calipers), clutch actuator
motor lead, clutch actuator sensor lead, rear wheel
sensor lead, and rear brake light switch lead with a
plastic locking tie. Face the end of the plastic
locking tie inward.
G. To clutch actuator
H. Fasten the rear wheel sensor lead to the brake
hose (brake pipe to rear brake caliper) with the two
holders, making sure that the fastener of each
holder faces inward.
CABLE ROUTING (FJR1300AS)
2-70