Fault code No.
46
Diagnostic code No.
Order Item/components and probable
cause
1
Connections
• Wire harness ECU coupler
2
Faulty battery.
3
Malfunction in rectifier/regulator
4
Open or short circuit in wire harness.
Fault code No.
50
Diagnostic code No.
Order Item/components and probable
cause
1
Malfunction in ECU.
Symptom Power supply to the fuel injection system is not normal.
—
—
Symptom Faulty ECU memory. (When this malfunction is detected in
the ECU, the fault code number might not appear on the
meter.)
—
—
FUEL INJECTION SYSTEM
Check or maintenance job
• Check the coupler for any pins
that may be pulled out.
• Check the locking condition of
the coupler.
• If there is a malfunction, repair it
and connect the coupler se-
curely.
• Replace or charge the battery.
Refer to "CHECKING AND
CHARGING THE BATTERY" on
page 8-240.
• Replace if defective.
Refer to "CHARGING SYS-
TEM" on page 8-29.
• Repair or replace if there is an
open or short circuit.
• Between battery and main
switch coupler.
(red–red)
• Between main switch coupler
and ignition fuse.
(brown/blue–brown/blue)
• Between ignition fuse and ECU
coupler.
(red/white–red/white)
Check or maintenance job
Replace the ECU.
NOTE:
Do not perform this procedure
with the main switch turned to
"ON".
8-96
Reinstatement
method
Starting the en-
gine and oper-
ating it at idle.
Reinstatement
method
Turning the
main switch to
"ON".