Yamaha FJR1300AS(X) Service Manual page 103

1. Auxiliary DC jack
2. Left radiator fan motor lead
3. Accessory box solenoid
4. Wire harness
5. Front cowling wire harness
6. Radiator inlet hose
7. Grip warmer control unit leads
8. Left radiator fan
9. Coolant reservoir breather hose
10. Left horn (low)
11. Left horn (low) leads
12. Coolant reservoir hose
13. Joint coupler
A. Fasten the handlebar switch leads and grip
warmer leads to the front cowling wire harness
with a plastic locking tie. Face the end of the plastic
locking tie rearward, along the side of the
accessory box. Do not cut off the excess end of the
plastic locking tie.
B. Fasten the wire harness and left radiator fan motor
lead with the holder.
C. Route the grip warmer control unit leads to the
front of the coolant reservoir hose.
D. Fasten the front cowling wire harness to the
radiator inlet hose with a plastic locking tie, making
sure to install the tie on the harness' protective
sleeve. Face the end of the plastic locking tie
upward. Do not cut off the excess end of the plastic
locking tie.
E. After connecting the couplers, cover them
completely with the cover, and then push them in
between the radiator inlet hose and the thermostat
inlet hose 2.
CABLE ROUTING (FJR1300A)
2-52