Yamaha FJR1300AS(X) Service Manual page 410

ECA13980
CAUTION:
Before tightening the crankcase bolts, make
sure the transmission gears shift correctly
when the shift drum assembly is turned by
hand.
6. Install:
• Crankcase bolts
NOTE:
• Lubricate the bolts "1"–"10" thread and wash-
ers with engine oil.
• Lubricate the bolts "11"–"31" thread part and
mating surface with engine oil.
• Apply locking agent (LOCTITE
of the bolt "16".
• Finger tighten the crankcase bolts.
• M9 × 115 mm bolts: "1"–"10"
• M8 × 65 mm bolt: "11"
• M8 × 50 mm bolt: "12"
• M6 × 80 mm bolts: "23", "25"
• M6 × 65 mm shoulder bolts: "13", "14"
• M6 × 65 mm bolts: "19", "22", "24", "26"
• M6 × 55 mm bolts: "15"–"18", "20", "21", "27"–
"30"
• M6 × 45 mm bolt: "31"
1
2
®
) to the threads
New
5-105
13 21 18
7 5
10
4
25
11
12
31
28
7. Tighten:
• Crankcase bolts (M9 × 115 mm) "1"–"10"
New
EW3P61013
WARNING
Replace the bolts with new ones.
NOTE:
The tightening procedure of crankcase bolts "1"–
"10" is angle controlled, therefore tighten the
bolts using the following procedure.
M MMM M MMM M M MMM M
a. Tighten the crankcase bolts in the proper
tightening sequence as shown.
Crankcase bolt "1"–"10"
1st
20 Nm (2.0 m·kg, 14 ft·lb)
b. Loosen and retighten the crankcase bolts in
the proper tightening sequence as shown.
Crankcase bolt "1"–"10"
2nd
20 Nm (2.0 m·kg, 14 ft·lb)
c. Tighten the crankcase bolts further to reach
the specified angle 115–125° in the proper
tightening sequence as shown.
Crankcase bolt "1"–"10"
Final
Specified angle 115–125°
CRANKCASE
17 20
16
15
19 22
1
3
9
6
2
8
23
14
24
29
30
27
26
M MMM M M MMM M M MMM M MMM