Configuring Traps - Hirschmann MS30, Power MICE, MACH 4000, OCTOPUS User Manual
Industrial ethernet gigabit switch
Hide thumbs
Also See for MS30, Power MICE, MACH 4000, OCTOPUS:
- Reference manual (572 pages) ,
- User manual (294 pages) ,
- Programming manual (116 pages)
Table of Contents
Advertisement
Operation Diagnostics
9.1.3 Configuring traps
V Select the Diagnostics:Alarms (Traps) dialog.
This dialog allows you to specify which events trigger an alarm (trap) and
to whom these alarms should be sent.
V In the "IP Address" column, enter the IP address of a network
management station to which the traps should be sent.
V In the "Active" column, you mark the entries which should be taken
into account when traps are being sent.
V In the frame "Selection" select these trap catagories from which you
want to send traps
Note: Access this dialog with read-write password.
Fig. 47:
Alarmes dialog
Layer 2 Enhanced with Layer 2 Professional
Release 1.0 10/05
9.1 Sending traps
135
Advertisement
Table of Contents
