Loading From A File - Hirschmann MS30, Power MICE, MACH 4000, OCTOPUS User Manual

Loading/saving settings

3.1.3 Loading from a file

The Switch allows you to load the configuration data from a file in the
connected network if there is no AutoConfiguration Adapter connected
to the Switch.
V Select the Basics:Load/Save dialog.
V Click in the Load"-frame "fromURL", if you want the Switch to load
the configuration data from a file and to retain the locally saved con-
figuration..
Click in the Load"-frame "from URL & save local", if you want the
Switch to load the configuration data from a file and to save this con-
figuration locally.
V In the "URL" edit box, type the field path under which the Switch finds
the configuration file.
V Click "Load configuration".
The URL identifies the path to the tftp server from which the Switch loads
the configuration file. The URL is in the form
tftp://IP address of the tftp server/path name/file name
(e.g. tftp://149.218.112.5/switch/config.dat).
Example of loading a file from the TFTPServer
V To enable yourself to download a file from the tftp server, save the
configuration file into the corresponding path of the tftp server with
the file name, e.g.. switch/switch_01.cfg (see
le" on page
V Enter the path to the tftp server into the line "URL", e.g.
tftp://149.218.112.214/switch/switch_01.cfg .
Note: The status of the load, started by DHCP/BOOTP (see
configuration via BOOTP" on page
tion "from URL & save local" in the "Load" frame. If you get an error mes-
sage while saving the configuration, one reason may be that loading is
not completed. DHCP/BOOTP does not finish loading until a valid confi-
guration is loaded. If DHCP/BOOTP does not find any valid configuration
you can stop the active loading by loading the local configuration in the
"Load" frame.
54
58).
3.1 Loading settings
39), is displayed in the selected op-
Layer 2 Enhanced with Layer 2 Professional
"Saving into a fi-
"System
Release 1.0 10/05