Hirschmann MS30, Power MICE, MACH 4000, OCTOPUS User Manual page 48

Entering the IP parameters
V Enter the parameters according to the selected mode on the right.
V You enter the system name applicable to the DHCP protocol in the Sy-
stem dialog of the Web-based Interfaces, in the "Name" line.
V In the "Local" frame assign
– an IP address,
– a Netmask and
– a Gateway Address
to the Switch.
V With the "VLAN ID" frame you can assign a VLAN to the Switch.
V The HiDiscovery protocol (see
ery" on page 35) allows you to assign an IP address to the Switch on the
basis of its MAC address. Activate the HiDiscovery protocol if you want to
assign an IP address to the Switch from your PC with the HiDiscovery
software delivered (setting on delivery: active).
Note: Save the settings you have made to ensure they are still available after
restart (see "Einstellungen laden/speichern" on page
48
2.8 System configuration via the Web-based
"Entering the IP parameters via HiDiscov-
Layer 2 Enhanced with Layer 2 Professional
51).
Release 1.0 10/05