Hirschmann MS30, Power MICE, MACH 4000, OCTOPUS User Manual page 140

Operation Diagnostics
V The events which can be selected are:
Name
Authentication The Switch has rejected an unauthorized access attempt (see the
Cold Start
Link Down
Link up
Spanning Tree The topology of the Rapid Spanning Tree has changed.
Chassis
Redundancy
Port Security
Bridge
Table 10: Trap categories
136
Bedeutung
Access for IP Addresses und Port Security dialog).
The Switch has been switched off.
At one port of the Switch, the link to the device connected there has been
interrupted.
At one port of the Switch, the link to a device connected there has been
established.
encompasses the following events:
– Power Supply: The status of a supply voltage has changed (see the
System dialog).
– Signaling Relay: The status of the signal contact has changed.
To cosider this event enable "generate Trap" in the
stics:Signal Contact 1/2
– An error has occurred in connection with the SNTP.
– A media module has been added or removed.
– The AutoConfiguration Adapter, ACA, has been inserted or removed.
– The value exceeded / fell below the temperature threshold.
The status of the HIPER-Ring or the redundant coupling of HIPER-Rings
/ network segments has changed.
On one port a data packet has been received from an unauthorized
terminal device (see Port Security Dialog).
Although the BPDU guard function is activited at a port a BPDU was
received (see User Manual Redundancy under „Rapid Spanning Tree").
Dialog.
Layer 2 Enhanced with Layer 2 Professional
9.1 Sending traps
Diagno-
Release 1.0 10/05