Configuring Basic Mld Snooping Functions; Enabling Mld Snooping - HP 5920 series Configuration Manual

Task at a glance

Configuring basic MLD snooping functions

•
(Required.)
•
(Optional.)
•
(Optional.)
•
(Optional.)
Configuring MLD snooping port functions
(Optional.)
(Optional.)
(Optional.)
Configuring MLD snooping policies
(Optional.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)
For MLD snooping, the configurations made on an aggregate interface do not interfere with the
configurations made on its member ports, and they do not take part in aggregation calculations. The
configuration made on a member port of the aggregate group takes effect after the port leaves the
aggregate group.
Configuring basic MLD snooping functions
Before you configure basic MLD snooping functions, complete the following tasks:
Configure the corresponding VLANs.
•
Determine the MLD snooping version.
•
• Determine the MLD last-listener query interval.
Determine the maximum response delay for MLD general queries.
•

Enabling MLD snooping

When you enable MLD snooping, follow these guidelines:
You must enable MLD snooping globally before you enable it for a VLAN.
•
MLD snooping for a VLAN works only on the ports in that VLAN.
•
To enable MLD snooping:
Step
1. Enter system view.
2. Enable MLD snooping
globally and enter
MLD-snooping view.
3. Return to system view.
Enabling MLD snooping
Specifying the MLD snooping version
Setting the maximum number of MLD snooping forwarding entries
Configuring parameters for MLD queries and responses
Setting aging timers for dynamic ports
Configuring static ports
Enabling MLD snooping fast-leave processing
Configuring an IPv6 multicast group filter
Configuring IPv6 multicast source port filtering
Enabling dropping unknown IPv6 multicast data
Setting the maximum number of IPv6 multicast groups on a port
Enabling the IPv6 multicast group replacement function
Command
system-view
mld-snooping
quit
101
Remarks
N/A
By default, MLD snooping is
disabled.
N/A