Flush Or Semi-Flush Enclosure Installations; Enclosure Cutout And Product Dimensions - Monogram ZIF36N RH Custom Options Manual And Installation Instructions

Advance Planning
Flush or
Semi-Flush
Enclosure
Installations
0"
Monogram built-in refrigerators and freezers can be
installed flush with typical 24-3/4" deep cabinetry.
When installed semi-flush, the case trim will conceal
slight gaps around the enclosure. The refrigerator or
freezer will project forward approximately 3/4" beyond
the front face of surrounding cabinetry.
In any installation situation, a wide range of appear-
ance options can be accomplished through the use of
one or more trim kits. See trim kit descriptions and
appearance options on page 6.
Enclosure
• To achieve a flush fit the finished cutout width must
Cutout and
be at least 36" wide.
Product
• A semi-flush installation requires 35-1/2" min. finished
Dimensions
cutout width.
• The electrical and water locations must be located as
shown for either type of installation.
*Shipped at 84" installation height.
Can be adjusted to 83-1/2" or 84-1/2"
with grille panel kits.
True Flush Installation
In a flush installation,
the refrigerator doors
will align evenly with the
front face of adjacent cabinet
doors. The refrigerator blends
into the surrounding cabinetry.
84"*
24-3/4" 36"
Design Information
36" Refrigerators, Freezers
3/4"
width. The case trim creates a
Side Panel Requirements:
• Side panels are not required whenever the
refrigerator is installed into an enclosure or between
pantry and oven cabinets.
• Side panels are required whenever the sides of the
refrigerator are exposed.
• Side panel sizes vary depending on the type of
installation being made.
To accomplish an attractive installation, you must:
1. Determine the need for side panels.
2. Determine side panel thickness.
3. Order matching side panels from the cabinet
manufacturer. Be sure to provide the exact
Sdimensions.
*Finished Width
2 1/2"
7"
5"
24 3/4" Total
84 1/2" max
Depth
83 1/2" min
Finished
Opening
5" Water Supply
3 1/2"
*36" Min. for a flush installation
35-1/2" Min. for a semi-flush installation
Note: Additional cutout width may be required when
side panels are used. Add side panel thickness to the
finished cutout to calculate rough-in width. See
installation examples on the following page.
Semi-Flush Installation
These refrigerators
can also be installed
semi-flush into an enclosure
using the minimum cutout
frame around the opening.
Wall View
Electrical
Area
74" From Floor
to Bottom
of Electrical
5"
3 1/2"
3