Monogram ZIF36N RH Custom Options Manual And Installation Instructions page 26

Step 1
Temporarily
mount door
panel
• Place the prepared 3/4" custom door panel on the
• Push the panel back against the steel door, making
• Secure the panel to the trim temporarily by driving 2
• Slide the handle extrusion in between the panel and
• Temporarily secure the extrusion to the door with 2
• Determine the location of the custom handles
Step 2
Locate
position
of handle
• Drill 1/16" pilot hole through the panel until it
• Remove the handle extrusion, the 2 temporary
Step 3
Assemble
• Drill 1/16" pilot hole through extrusion.
panel,
extrusion and
• Drill clearance holes through the panel and
handle
• Assemble the panel, extrusion and custom handle.
• Install screw(s) long enough to pass through the
26
bottom trim with support bracket tabs inserted into trim
slots.
sure the panel is flush with the hinge side trim.
screws through the backside of the trim at the top.
steel door.
screws.
and carefully mark centerlines of the screw
holes. The handles must be located 3/4" to
1-1/2" from the edge of the extrusion.
starts into the aluminum extrusion. This will
mark the matching location for drilling a
clearance hole when assembling the
extrusion, panel and handle.
screws and custom panel.
extrusion.
extrusion, door panel and into the handle.
ZKHTR1 Trim Kit (For 3/4" Panel)
Support for Custom Handle
3/4" Min.
1-1/2" Max.
Screw
3/4" Min.
1-1/2" Max.