Flush Or Semi-Flush Enclosure Installations; Enclosure Cutout And Product Dimensions - Monogram ZIRS36N LH Installation Instructions Manual

Stainless steel 36" built-in refrigerators and freezers
Hide thumbs Also See for ZIRS36N LH:
Table of Contents

Advertisement

Advance Planning
Flush or
Semi-Flush
Enclosure
Installations
0"
Monogram built-in refrigerators and freezers can be
installed flush with typical 24-3/4" deep cabinetry.
When installed semi-flush, the case trim will conceal
slight gaps around the enclosure. The refrigerator will
project forward approximately 3/4" beyond the front
face of surrounding cabinetry.
Enclosure
Cutout and
Product
Dimensions
*Shipped at 84" installation heigt. Can be adjusted to 83-1/2"
front face of adjacent cabinet
doors. The refrigerator blends
into the surrounding cabinetry.
• To achieve a flush fit, the finished cutout width must
be at least 36" wide.
• In a semi-flush installation, the finished cutout must
be 35-1/2".
• The electrical and water locations must be located as
shown for either type of installation.
24-3/4"
36"
or 84-1/2" with grille panel kits.
Design Information
3/4"
True Flush Installation
In a flush installation,
the refrigerator door
will align evenly with the
Side Panel Requirements:
• Side panels are not required whenever the
refrigerator or freezer is installed into an enclosure or
between pantry and oven cabinets.
• Side panels are required whenever the sides of the
product are exposed.
• Side panel sizes vary depending on the type of
installation being made.
To accomplish an attractive installation,
you must:
1. Determine the need for side panels.
2. Determine side panel thickness.
3. Order matching side panels from the cabinet
manufacturer. Be sure to provide the exact dimen-
sions.
84"*
*36" for for a flush installation.
35-1/2" Min. for a semi-flush installation.
Note: Additional cutout width may be required when side panels
are used. Add side panel thickness to the finished cutout to
calculate rough-in width. See installation examples on
the following page.
36" Stainless Steel Refrigerators, Freezers
Semi-Flush Installation
semi-flush into an enclosure
using the minimum cutout
width. The case trim creates a
frame around the opening.
*Finished Width
2 1/2"
Electrical
Area
7"
5"
24 3/4" Total
84 1/2" max
Depth
83 1/2" min
Finished
Opening
5"
Water Supply
3 1/2"
These refrigerators
can also be installed
Wall View
74" From Floor
to Bottom
of Electrical
5"
3 1/2"
3

Advertisement

Table of Contents
loading

This manual is also suitable for:

Zirs36n rhZifs36n lhZifs36n rh

Table of Contents