Flush Or Semi-Flush Enclosure Installations; Enclosure Cutout And Product Dimensions - Monogram ZIRS36N LH Installation Instructions Manual

Advance Planning
Design Information
36" Stainless Steel Refrigerators, Freezers
Flush or
Semi-Flush
Enclosure
Instollations
True Flush Installation
In a flush installation,
the refrigerator door
will align evenly with the
front face of adjacent cabinet
doors. The refrigerator blends
into the surrounding
cabinetry.
Honogram built-in refrigerators and freezers can be
installed flush with tupical 24-3/4" deep cabinetry.
When installed semi-flush, the case trim will conceal
slight gaps around the enclosure. The refrigerator
will project forward approximatel U 3/4" beyond the
front face of surrounding cabinetry.
Semi-Flush Installation
These refrigerators
can also be installed
semi-flush into on enclosure
using the minimum cutout
width. The case trim creates o
frame around the opening.
Side Panel Requirements:
• Side panels are not required whenever the
refrigerator or freezer is installed into an enclosure
or between pantry and oven cabinets.
• Side panels are required whenever the sides of the
product are exposed.
• Side panel sizes varg depending on the type of
installation being made.
To accomplish an attractive installation, gou must:
1. Determine the need for side panels.
2. Determine side panel thickness.
S. Order matching side panels from the cabinet
manufacturen Be sure to provide the exact
dimensions.
Enclosure
Cutout and
Product
Dimensions
• To achieve a flush fit, the finished cutout width
must be at least 56" wide.
• In a semi-flush installation, the finished cutout must
be 35-1/2".
• The electrical and water locations must be located
as shown for either type of installation.
35" 24-3/4"
Case _LCase
Width/Depth
84 "e
26-3/4",..._36" Frame to Frame
Including
Tubular
Handles
I
84-1/2" max
83-1/2" rain
Finished
Opening
£
_Finished Width-
./1
,_--2-1/2" [] Wall View
_- ,f_Electrical
II
II1- Area
-M'
5"
_-24-3/4" Total II 75" FromFloor
Depth I I to Bottom
II of Electrical
-5'z_-/3-1/2" Water Supply3-1/2 X'L_L 5" t! Area
iN_
-10" 3-1/2" 10'
*36" for a flush installation.
j 55-1/2" Hin. for a semi-flush installation.
NOTE: Additional cutout width may be required when side
panels are used. Add side panel thickness to the finished
cutout to calculate rough-in width. See installation
examples on the following page.
*Shipped Qt 84" installation height.
Can be odjusted to 83-1/2"
or 84-1/2"with grille panel kits.