Monogram ZIF36N RH Custom Options Manual And Installation Instructions page 39

Step 9
Install
Soffit
Vent Top
• Separate the top and hinge side trim pieces by
• Install one end piece to unified top piece with 2
• Slip end of rubber dust gasket into end of top unified
• Reinstall end pieces to case trims. Push top piece up
• Whenever possible, place a level on the top trim.
Step 10
Secure
Custom Panel
To Support
• Secure the grille panel support to the back side of the
Note: Use screws supplied with ZKTR36 Trim Kits.
Into Trim On One End
removing side screws. Discard top piece, retain
screws.
original screws.
piece and slide trim towards the center. Engage the
second piece of gasket and continue sliding trim until
even with opposite ends.
against soffit or to installation height. Tighten screws
on both sides.
Adjust side trims until entire grille frame is level.
3/4" thick custom panel with #6 screws. Be sure the
lip of the support is over the top of the wood panel.
Panel Support
Overlaps Top
ZUG75 Trim Kit
Slip Dust Gasket
• Install four of the six larger undercut screws so that
the top of the screws are 1/16" from the surface of the
support.
1/16"
• Attach the assembled panel to the grille opening by
inserting the four protruding screws into the brackets
on each side.
Unified 3/4" Custom Grille Panel
Slip Second Dust
Gasket Into Trim
Reinstall
Screws
Back View
Grille Panel Support
39