Monogram ZIF36N RH Custom Options Manual And Installation Instructions page 32

Kit Right hand door swing models are illustrated in these
Contents
instructions. Follow these instructions for left hand
models.
This kit provides for the installation of a Tubular
Stainless Steel handle on a 3/4" thick decorator door
panel. The door extrusions allows the custom handle to
be secured to the door structure, rather than to the
custom panel.
• Select the extrusion for your model, discard other
Tools and materials required:
• #2 Phillips screwdriver
• Drill and 1/8", 9/32" bits
• Custom door panel
• Safety glasses
• Center punch
• Masking tape
• Hammer
• Pencil
Parts List:
A. Handle extrusion (for left hand models)
B. Handle extrusion (for right hand models)
C. Stainless tubular handle
D. 4 Handle standoffs
E. 6 Screws for handle standoffs
F. 6 Set screws (4 required, 2 extra)
G. 3/32" Allen wrench for set screws
Before
• The 3/4" custom panel must be routed to
you begin:
• Follow the instructions in the ZKTR36RH (or
• Continue the instructions in the ZKTR36RH (or
32
extrusion.
(4 required, 2 extra)
accommodate the handle extrusion. Rout the
panel as illustrated, 1/4" deep, and 1-13/16"
wide, top to bottom on the handle side.
ZKTR36LH) to install trim onto the door. Discard
the handle supplied with that kit.
ZKTR36LH) trim kit to install support brackets to
the bottom of the panel.
ZKHTRSS1 for 3/4" panel
Tubular Stainless Steel Handle
This kit must be used in combination with ZKTR36RH or
ZKTR36LH, trim kit.
Note: It is best that 2 people install this kit.
A
B
C
D
E
G
1-13/16"
1/4" Max.
Handle Side
IMPORTANT: Optional final appearance depends on
careful routing depth. Do not exceed 1/4" routing depth.
F
Custom Panel
Back Side