Monogram ZIF36N RH Custom Options Manual And Installation Instructions page 35

This kit provides for the installation of a 3/4" thick
custom grille panel to span the combined width of a
side by side installation. Use this kit in combination
with 3/4" custom panel kits, ZKTR36 LH and ZKTR36RH.
Tools and materials
Required:
• #1 and #2 Phillips screwdrivers or sockets
• 1/4" angled wrench and 1/2" open ended
• Drill and appropriate bits
• Custom grille panel
• Safety glasses
• Gloves to protect against
Parts List:
A. Soffit Vent Top
B. Left Side Case Trim
C. Right Side Case Trim
D. Center U-Shape Trim
E. Grill Base Wrap
Step 1 CAUTION: Handle parts with care to avoid scratching.
Install Spacer Pads,
Replace Side Case
In a side by side installation, the inside case trim of
Trims
both products will be removed and replaced with a
shorter trim.
• Lift up to remove the supplied grille panel assembly
on both products. Discard both assemblies.
• Apply the supplied foam spacer pads to the mating
wrench
sharp edges
F. Custom Grille Panel Support
G. Foam Spacer Pads
side of one product as shown.
ZUG75 Trim Kit
Unified 3/4" Custom Grille Panel
Completion Time: Allow approximately 3 hours to
install this kit.
IMPORTANT: 2 People are required to install this kit.
CAUTION: Disconnect power before you begin.
A
B
C
D
E
F
G
Foam
Spacer
• Remove the Phillips head screws from the inside case
Pads
trim of each product as shown. Remove and discard
side trim. Retain screws.
• Install new side case trim with notches towards the
bottom. Install with original screws.
35