Monogram ZIF36N RH Custom Options Manual And Installation Instructions page 25

Kit Contents
Right hand door swing models are illustrated in these
instructions. Follow these instructions for left hand
models.
Tools and materials required:
• #2 Phillips screwdriver
• Drill and appropriate bits
• Custom door panel
• Custom handle
• Safety glasses
Note: This kit must be used in combination with ZKTR36LH
or ZKTR36RH trim kit for 3/4" panel trim.
Part List:
A. Handle extrusion (for left hand models)
B. Handle extrusion (for right hand models)
This kit provides the necessary framework to install a
custom handle, of your choice , onto a 3/4" thick
decorator door panel. (Handles not included.) The
handle extrusion allows the custom handle to be
secured to the door structure, rather than the door
panel.
• Select handle extrusion for your model, discard other
Before 3/4" custom door panel must be routed to accommodate
you begin
these door handle extrusions. Rout the panel as
illustrated, 1/4" deep, and 1-13/16" wide on the handle
side.
Refer to installation instructions for ZKTR36LH or
ZKTR36RH trim kit for 3/4" custom panels:
• Follow Step 1 to remove the standard aluminum trim.
• Follow Steps 2 and 3 to attach new 3/4" trim pieces
extrusion.
and to install panel support brackets.
ZKHTR1 Trim Kit
Support for Custom Handle
Custom Panel
1-13/16"
1/4" Max.
Handle Side
Important: Optimal final appearance depends on careful
routing depth. Do not exceed 1/4" routing depth
Back Side
25