Monogram ZIF36N RH Custom Options Manual And Installation Instructions page 30

• Place a handle standoff onto each attachment post
Step 3
Install
standoffs
onto handles
• Install set screws into the bottom of each standoff,
• Slide panel into the door trim. Leave about 4" of the
Step 4
Install
handles
and panels
• Place extrusion onto the back side of the panel, install
FOR CUSTOM
WOOD
• Drive screw part way through the top standoff, then
PANELS
See Step 4A
• Drive all screws until the handle is tight against the
for stainless
steel panels
• Remove tape.
• Slide the assembled panel into the door trim until the
30
along the handle. Position the set screw hole on the
standoff to point to the floor.
using the Allen wrench provided. The standoff should
be tight against the handle.
panel exposed to allow room to install the handle
extrusion.
mounting screws through the extrusion and just
through the panel.
part way through the bottom standoff. Install remain-
ing standoffs part way.
panel.
extrusion fits firmly against the steel door. Reinstall
original screws into the extrusion.
ZKHRSS1 Trim Kit
Tubular Stainless Steel Handle on 1/4" Panel
Screw
Allen Wrench
Screw
Decorator
Door Panel
Handle