Monogram ZIF36N RH Custom Options Manual And Installation Instructions page 33

Step 1 • Cut a piece of corrugated to use as a pad to protect
Match Handle
Extrusion
to Panel
• Place custom panel on the pad, appearance side
• Select handle extrusion for your model, left or right
• Place extrusion against the handle side of the panel.
• Align the extrusion evenly with the top and bottom of
• Tape the extrusion to the panel to prevent movement.
• Center punch and drill 1/8" pilot holes through the
• Turn panel over. On the appearance side, use 9/32" bit
• Place a handle standoff on each attachment post on
Step 2
Install
Standoffs
onto Handles
• Install set screws into the bottom of each standoff,
• Start mounting screws through the extrusion and just
Step 3
Install
mounting
• Stand panel up on the hinge side and hold to access
screws
and handles
• Drive bottom screw partially into the standoff, and
It is best that 2 people perform this step.
Step 4
Install
• Place assembled panel onto the bottom door trim
Assembled
Panels
• Push and hold the panel back against the steel door
• Reinstall original screws into the door extrusion.
• Open the door fully to stop.
• Install screws at the top, and hinge side.
the panel finish. Additional material may be required
to protect flooring when drilling.
down.
side extrusion.
the panel.
holes in the extrusion and into the panel.
to enlarge clearance hole.
the handle. Position the screw hole on the standoff
to point to the floor.
using the Allen wrench provided. The standoff
should be tight against the handle.
through the custom panel.
the appearance side. Place handle against mounting
screws on the appearance side, drive top screw from
the back of the extrusion partially into the standoff.
then, drive remaining screws partially into standoffs.
Alternate back to the top, driving screws until the
handle is tight against the door.
with support bracket tabs inserted into slots.
with door handle extrustion flush to the handle side
of the door.
ZKHTRSS1 for 3/4" Panel
Tubular Stainless Steel Handle
Align ExtrusionEven
With Panel
Back Side
Custom Panel
Note: Hole locations must be exact to accept handle
standoff and handle assembly.
Screw
Allen Wrench
33