Monogram ZIF36N RH Custom Options Manual And Installation Instructions page 34

For the ultimate in convenience, install a refrigerator
and freezer side by side.
This trim kit includes 6 foam spacer pads to fill the gap
between the side case trims. For a finished appearance,
a trim strip is provided to conceal the case trim of the
two products.
If you are installing into an enclosure, a 72" min. wide
opening is required. If you are installing where the sides
will be exposed, allow additional width for any side
panels used.
• Apply foam spacer pads evenly to the side of one
refrigerator or freezer as shown.
• Slide second product into position.
• Check to be sure both products are level. If they are
not level, an obvious gap can be seen between the
side trims. Adjust leveling legs if needed. Slight gaps
will be concealed with the trim strip.
• Open both doors to access side trim.
• The U-shape trim will overlap the side case trim of
both refrigerators.
• Set the top case trim (see page 17) to installation
height.
• Hold trim strip against top end of product case trim, at
the point where case overlaps to the bottom of case
trim. See illustration.
• Mark length with a pencil at the bottom.
• Trim excess length.
• Starting at the top, press trim strip over case trims of
both products.
• Continue pressing trim until you reach the bottom of
the strip.
34
ZFC1 Trim Kit
Side by Side Installation
Case Trim
Foam
Spacer
Pads
U-Shape
Trim