Monogram ZIF36N RH Custom Options Manual And Installation Instructions page 31

Step 4A
Install
handles and
panels
FOR
STAINLESS
STEEL
PANELS
• Crimp top and bottom edges of corrugated.
• Slide corrugated into door trim. Leave about 1/4" gap
Note: Panels have a protective plastic covering. Peel
away just enough to allow panel to slide into trim and to
clear handle mounting screws. The plastic covering will
keep the panel clean during the installation process.
Be sure to maintain 1/4" gap between corrugated and
hinge side trim.
Raised Panel on 1/4" Thick Backing:
A raised panel design secured to a 1/4" thick backing
(screwed or glued) can be used with this handle kit.
• Cut the 1/4" thick panels to size.
• Fabricate the raised panel to allow 1-1/4" clearance
• Allow 5/16" clearance at the other edges to allow for
• Total panel thickness should not exceed 3/4".
• Countertops adjacent to the refrigerator installation
Note: Longer Screws, obtained locally, will be required to
accommodate panel thickness. Use stainless steel
#10-32x1-1/4" truss Phillips head screws.
between edge of corrugated and hinge side trim of
the door.
from the hinge side of the panel to avoid striking
adjacent cabinetry.
the trim flange.
should be mitered 45°.
ZKHRSS1 Trim Kit
Tubular Stainless Steel Handle on 1/4" Panel
Spacer
Corrugated
Ring
Stainless
Panel
Handle
• Slide panel into the door trim. Leave about 4" of the
panel exposed to allow room to install the handle
extrusion.
• Place a spacer ring over each screw hole on the
extrusion. Use tape to hold in place.
• Place extrusion onto panel. Use a pencil to punch
hole in tape covering spacer rings and align with
screw holes.
• Install mounting screws through the extrusion and
panel.
• Drive screw part way through the top standoff, then
part way through the bottom standoff. Install remain-
ing standoffs part way.
• Drive screws until the handles are tight against the
panel.
• Slide the assembly into the door trim until the
extrusion fits firmly against the steel door.
• Reinstall original screws into the door extrusion.
Raised Panel on 1/4" Thick Backing
1/4"
Appearance
Thick
Panel
Backing
5/16"
Clearance
handle Side
Screw
Extrusion
5/16" Clearance
Custom Panel
1-1/4"
Clearance
hinge side
5/16" Clearance
5/16" Clearance
31