Monogram ZIF36N RH Custom Options Manual And Installation Instructions page 16

• Remove internal packing materials.
Step 9
Arrange
• Remove tape from all shelves.
Interior
• Connect power cord plug to a properly grounded
Step 10
Connect
Power
• Check to make sure power is on by opening the door
Step 11 If you are using a 3/4" thick custom panel, SKIP THIS
Mount
STEP. See Dimensions and Specifications for grille
Top Grille
panel sizes. Order ZKTR36LH or ZKTR36RH and follow
Panel
the installation instructions packed with the kit.
The grille panel frame is factory assembled for an 84"
installation height. If installation height varies, order
ZGC2 trim kit which provides optional side trim pieces
for 83-1/2" and 84-1/2" heights.
Cut 1/4" thick custom panel to fit the frame,
35-1/8" wide, 8" deep (for an 84" installation).
To insert custom grille panel into the frame:
• Remove screws (2 on each top corner) and "L"
• Slide panel into the frame and reassemble.
• Mount the grille panel by dropping into slots on the
• For shipping purposes, the top case trim is secured at
To raise case trim to 84-1/2" or to lower to 83-1/2"
installation height:
• Loosen 2 screws on both sides and raise the top or
• Tighten all 4 screws.
Important : Maintain 1-1/2" min. gap between top of doors and
bottom of panel frame.
16
receptacle, accessible through the top left side of the
grille opening.
to see if interior lights are on.
brackets on each side.
case trim.
84" installation height.
lower case trim to meet soffit height or to the top of
adjacent cabinets.
1-1/2"
min.
gap
Installation
36" Refrigerators, Freezers
Top Case Trim
Raise To
Installation
Height
Screws