Monogram ZIF36N RH Custom Options Manual And Installation Instructions page 14

Step 3
• Side panels are not required when the refrigerator or
Install
Side Panels
• Side panels are required whenever the sides of the
• Side panel installation will be determined by the
• Side panels must be installed plumb.
Illustration A
1/4" Side panels - Insert end of side panel into case
trim. Fasten with Velcro strips provided.
Step 4
Install
Anti-Tip
Brackets
• Cut a 2" x 4" x 35" block and secure the block to
• Secure the bracket with wood block to the back wall
• Screws must penetrate at least one inch into vertical
• Gently push refrigerator into the opening with hands
14
freezer is installed into an enclosure. Skip this step if
you are installing into an enclosure.
refrigerator or freezer will be exposed and when
installed between frameless cabinets. See pages 3
and 4.
design of the side panel you have previously chosen.
Refrigerator
Cabinet
Refrigerator door
Cabinet
CAUTION
WARNING
ANTI-TIP PRECAUTIONS
The refrigerator is top-heavy and must be secured to
prevent the possibility of tipping forward.
ATTENTION
PRECAUTIONS CONTRE LES BASCULEMENTS
Le réfrigérateur est beaucoup plus lourd en haut et
il faut le maintenir en place pour éviter la
possibilité de son basculement vers l'avant.
the mounting brackets provided using #12 or #14 wood
screws.
so that it is 84" (or your installation height) from the
finished floor. Use #12 or #14 wood screws. See
illustration.
wall studs.
against front corners.
Installation
36" Refrigerators, Freezers
• If you choose to use 1/4" side panels, they should be
inserted into the case trim as illustrated. Fasten the
panels to the refrigerator with stick-on hook and loop
fastener strips before setting refrigerator in place.
See illustration A.
• 1/2" to 3/4" side panels are normally set into place and
fastened to adjacent cabinetry or the back wall before
rolling the refrigerator into the opening. See illustra-
tion B.
Illustration B
1/2" to 3/4" Side Panels - Leading edge of side panel is
flush with cabinet front. Fasten to the back wall using a
cleat.
Block
Brackets
Required
Side View
2 x 4 Cut
35" Length
Installation
Height
From Floor
Screws Mounted into
Vertical Wall Studs
Important Note: When the refrigerator is installed under a soffit
or if there is not enough height for this method of security,
brackets cannot be used. Proceed to step 5 to level the
refrigerator and then to step 6 to secure refrigerator to cabinets.
The refrigerator must be secured to prevent tipping.
Refrigerator
Cabinet
Refrigerator door
Soffit
Brackets
Not Required
Beneath a
Soffit
Height
From
Floor
to
Bottom
of Wood
Block
Mounting
Bracket