Monogram ZIF36N RH Custom Options Manual And Installation Instructions page 20

Step 2
Locate
handle
position
• Slide custom panel into the door trim.
• Temporarily secure the new handle extrusion to the
• The custom handles must be located 3/4" to 1-1/2"
Step 3
Assemble
panel,
extrusion and
handle
• Remove the handle extrusion and custom panel.
• Drill 1/16" pilot hole through extrusion.
• Drill clearance holes through the panel and extrusion.
• Assemble the door panel, extrusion and custom handle.
• Install screw(s) long enough to pass through the
extrusion, door panel and into the handle.
• Slide the assembly into the door frame until the new
extrusion fits firmly against the steel door.
• Reinstall original screws into the door extrusion.
20
door using at least 2 screws.
from the edge of the extrusion.
Decorator
Door Panel
Handle
ZKHR1 Trim Kit
Support for custom handle on 1/4" panel
• Determine the desired location of the custom handle
and mark centerlines of the screw holes.
• Drill 1/16" pilot hole through the panel until it starts
into the aluminum extrusion. This will mark the
matching location for drilling the clearance hole when
assembling the handle, panel and extrusion.
Decorator
Door
Panel
Extrusion
3/4" Min.
1-1/2" Max.
3/4" Min.
1-1/2" Max.
Screw