For Stainless Steel Models Zifs240, Zibs240; Flush And Standard Installation; Product Clearances - Monogram Fresh Food Custom ZIFI240 Installation Instructions Manual

For Models ZIFS240 and ZIBS240 with Stainless Steel Door Panels and Handles
THE INSTALLATION SPACE
For a flush installation
Install a 1/4"-wide filler strip on the hinge side. The filler
strip will act as a spacer between the door case and
adjacent cabinets and will prevent interference with the
cabinet door swing. Recess the filler strip 1-5/8" back
from the front face of the refrigerator, or even with the
front edge of the product case (behind the gasket). The
width of the opening must be 24" (including the 1/4" filler
strip).
Installation
Filler panel or cleat to be set
CABINET
back even with front of case.
Front edge of product case
Front face
For a standard installation
The product must be installed so that the product front
will project forward of the adjacent cabinets by the
dimensions T or U according to the model in the chart.
This position will allow a full door swing and prevent
interference with adjacent cabinetry. The opening
between cabinets must be a minimum of dimension K.
Installation
CABINET
Front edge of product case
T,U
Front face
In a standard installation, the product
will project forward of adjacent
cabinets. See T,U.
Product Extended Dimension
T ZIFS240
U ZIBS240
8
Design Guide
for Flush and Standard Installation
Flush
1/4"
CABINET
110°
120°
Standard
CABINET
110°
120°
1-5/8"
2-5/8"

PRODUCT CLEARANCES

The Fresh-Food Refrigerator or Bar Refrigerator with
Icemaker is factory set for a 110° door swing.
When installed in a corner:
• Allow 14" minimum clearance on the hinge side for a
full 110° door swing.
• Allow 4" min. clearance on the hinge side for the 90°
door swing and to allow racks to slide out.
14" Minimum to Wall
110 Door
Swing
110
NOTE: Clearances are based on the recommended
2-1/4" handle standoff depth.
NOTE: Right hand models illustrated. Allow the same
clearances on the opposite side for left hand fresh food
model ZIFS240 only. Model ZIBS240 is not available
with left hand door swing.
• Test the door swing. Carefully open and close the
door. The door should not rub or catch on adjacent
cabinetry.
Choose the location:
• These products may be closed in on the top and
three sides as long as the front is unobstructed for air
circulation and proper access to the door.
• Do not install these products where the temperature
will go below 55°F (13°C) or above 100°F (37°C).
• These products are not designed to be stacked one
over the other.
90 Door
B
Swing
R
F
90
4" Minimum to Wall
31-1000642