Monogram ZIF36N RH Custom Options Manual And Installation Instructions page 29

Step 2
• Cut a piece of corrugated to use as a pad to protect
Match
handle
extrusions
• Place custom panel on the pad, appearance side
to handle
FOR CUSTOM
• On the back side of the panel - at the handle side,
WOOD
PANELS
See Step 2A • Slip panel into new extrusion on the handle side of
for Stainless
Steel panels
• Align the extrusion at the pencil mark, 1/4" below the
• Tape the extrusion to the panel to prevent movement.
• Center punch and drill 1/8" pilot holes through the
• Turn panel over. On the appearance side, use 9/32" bit
IMPORTANT: Hole locations must be exact to accept
handle standoff and handle assembly.
If you are installing handle onto a Stainless Steel
Step 2A
Panel:
FOR
Use extreme caution if you are drilling through a
STAINLESS
stainless steel panel. Stainless steel panels must be
STEEL
handled gently. Do not kneel on the stainless steel
PANELS
panel. It will leave a permanent dent. Do not remove
protective plastic covering until final installation.
• Place supplied filler panel (corrugated) on floor to use
• On the back side of the panel - at the handle side,
• Slip panel into the new extrusion, flush against inner
• Align extrusion to pencil mark as shown in Step 2.
• Tape extrusion to panel to prevent movement.
the panel finish. Use 1/2" thick section of plywood to
protect flooring when drilling.
down.
measure and mark 1/4" below the top edge of the
panel with a pencil.
the panel.
top of the panel.
holes in the extrusion and into the panel.
to enlarge clearance hole.
as a pad.
measure and mark 1/4" below the top edge of the
panel.
edge, on the handle side.
Mark each screw hole location with pencil.
ZKHRSS1 Trim Kit
Tubular Stainless Steel Handle on 1/4" Panel
Custom
Door
Panel
• Place panel on plywood section, appearance side
down. Be sure plywood is clean without nicks and
burrs. Center punch at each screw hole location.
• Drill 1/8" pilot hole. Use 9/32" bit to enlarge clearance
hole.
• Measure and cut a 2" wide strip, top to bottom off the
corrugated panel. This will allow room for spacer
rings between the stainless panel and extrusion.
Back
Side
Custom
Panel
Extrusion
29