Projector setup (continued)
Installation Setting
A projection scheme can be chosen depending on
the installation of the projector. If the picture is shown
upside down or in reverse, change the projection
scheme.
•
Select the setting by displaying the on-screen
indications using buttons of the remote control or
the control panel on the main unit.
Press ▲▼ to select
1.
"INSTALLATION".
PROJECTOR ID
INSTALLATION
ALTITUDE MODE
Press ◄► to switch
2.
"INSTALLATION".
•
The setting will change as follows each time
◄► is pressed.
FRONT-FLOOR
REAR-CELING
Floor mount front projection (FRONT-FLOOR)
Ceiling mount front projection (FRONT-CEILING)
Floor mount rear projection (REAR-FLOOR)
Ceiling mount rear projection (REAR-CEILING)
78 – ENGLISH
ALL
FRONT-FLOOR
ON
FRONT-CELING
REAR-FLOOR
3.
Press MENU twice.
•
The on-screen indications disappear and the
normal screen appears again.
Altitude Mode
When using the projector over 1 400 m above sea
level, set to "ON".
Press ▲▼ to select "ALTITUDE
1.
MODE".
INSTALLATION
ALTITUDE MODE
DIRECTION
Press ◄► to switch "ALTITUDE
2.
MODE".
•
The setting will change as follows each time
◄► is pressed.
OFF
Direction
The fan speed is changed in accordance with the
projector orientation (pointed forward, or toward the
ceiling or floor)
Press ▲▼ to select
1.
"DIRECTION".
ALTITUDE MODE
DIRECTION
LAMP SELECT
Press ◄► to switch
2.
"DIRECTION".
•
The setting will change as follows each time
◄► is pressed.
HORIZONTAL
•
HORIZONTAL:
This is the standard setup.
•
VERTICAL:
Select this if the projector is tilted at a large vertical
angle (an angle which exceeds 30° from the
horizontal).
FRONT-FLOOR
ON
HORIZONTAL
ON
ON
HORIZONTAL
QUAD
VERTICAL