Using The Remote Control Unit; Effective Range Of Remote Control Operation - Panasonic PT-D12000U Operating Instructions Manual

Using the remote control unit

Loading batteries
When loading supplied AA batteries into the battery
compartment of the Remote Control, make sure that
their polarities are correct.
1. Open battery compartment lid.
• Open the lid in the order
$
2. Insert the batteries.
• Into battery compartment, with their
polarities orientated as indicated (⊕,⊖) in the
compartment.
Supplied AA batteries
(insert the ⊖ side first).
3. Close the battery compartment
lid.
• Replace the battery compartment lid over the
compartment and slide until it clicks.
Attention
• Do not drop the Remote Control unit.
• Do not expose Remote Control unit to any liquid.
• Do not use NiCd batteries.
• Release the LOCK button before operating the
remote control. (p. 13)
1 and then 2 .
#
Effective range of remote
control operation
The Remote Control should normally be aimed at
either the front or rear remote control receiver window
on the projector (figure 1).
The effective control range is approx. 30 metres from
the beam receiver on the front or rear.
Otherwise, it may also be aimed at the screen, which
will reflect commands back to the projector's front
receiver window as illustrated in figure 2.
• When the Remote Control is aimed at the screen,
the effective control range may be reduced due to
the optical loss by screen reflection.
Figure 1
• Top View
(Front)
30°
Remote
30°
Control
• Side View
Remote
Control
30° 30°
15°
Remote
15°
Control
Figure 2
Screen
Remote
Remote Control
Control
receiver window
(front)
(Rear)
30°
Remote
30°
Control
15°
Remote
15°
Control
30° 30°
Remote
Control
Projector
Remote Control
receiver
window (rear)
ENGLISH – 17