Registration Of Input Signal Data - Panasonic PT-D12000U Operating Instructions Manual

Registration of input signal data

MENU
The input signal data must be registered because
it is not registered on shipment of the projector.
MENU
Press to display the MAIN
MENU screen.
Press to select "SIGNAL
LIST".
Press to display the
"REGISTERED SIGNAL
LIST" menu.
• The memories extend
over 12 pages (A to L with
8 data items each, giving
a total of 96 memories).
MAIN MENU
PICTURE
POSITION
ADVANCED MENU
DISPLAY LANGUAGE
DISPLAY OPTION
PROJECTOR SETUP
P IN P
TEST PATTERN
SIGNAL LIST
SECURITY
NETWORK
MENU SELECT
SUB MENU
ENTER
Registration of new data
When a new format input signal is applied to the
projector, press MENU on the remote control or
operating section of the main unit. When its data
has been registered, the "MAIN MENU" screen is
displayed.
Note
• The data of 96 input signals can be registered in the
▲▼◄►
projector's memory.
ENTER
• Signals appropriate to the optional input cards
will also be registered in the memories as they are
input.
• The 96 memories are numbered over 12 pages (A
to L: 8 data items can be registered on each page),
and the data is registered in the unused memory
location with the lowest number. If all the memories
are filled, the data of the old signals is overwritten in
sequence.
• The names of the registered data are automatically
DEFAULT
determined according to the type of signal and the
available memory number, but they can be renamed
as described below.
• If a menu is being displayed, the new signals will be
registered at the instant they are input.
Renaming the registered signals
Press ▲▼◄ ► to select the
1.
signal whose details are to be
displayed.
REGISTERED SIGNAL LIST
A1:SVGA72-A1
A2:SVGA72-A2
A3:SVGA72-A3
2. Press ENTER.
• The "REGISTERED SIGNAL STATUS" screen
will be displayed.
REGISTERED SIGNAL STATUS
NAME
MEMORY NO
INPUT
fH
fV
SYNC.STATE
• The data items including the input signal name,
memory number, input terminal, frequency and
sync signal are automatically identified and
displayed.
• When MENU is pressed, the "REGISTERED
SIGNAL LIST" screen is restored.
3. Press ENTER.
• The "RENAME" screen will be displayed.
RGB1 −−−
RGB1 −−−
RGB1 −−−
SVGA72-A2
A2
RGB1
48.08kHz
72.17Hz
H(POS)
V(POS)
ENGLISH – 45