Table of Contents
Advertisement
Initial setting (installation setting 1)
Set [PROJECTION METHOD] depending on the installation mode. Refer to "Installation mode" (x page 35) for details.
Set [HIGH ALTITUDE MODE] to [ON] when using the projector at high altitudes between 1 400 m (4 593') and 2 700 m (8 858') above sea
level.
After completed the initial setting, you can change the settings of each item from the [PROJECTOR SETUP] menu.
1)
Press as to select an item.
2)
Press qw to switch the setting.
3)
Press the <ENTER> button to proceed to the initial setting.
Initial setting (installation setting 2)
Set [COOLING CONDITION] depending on the installation mode. Refer to "Installation mode" (x page 35) for details.
After completed the initial setting, you can change the setting from the [PROJECTOR SETUP] menu → [COOLING CONDITION].
1)
Press qw to switch the setting.
2)
Press the <ENTER> button to proceed to the initial setting.
Chapter 1 Preparation — Start-up display
INITIAL SETTING
PROJECTION METHOD
When PROJECTION METHOD is changed, confirm that
COOLING CONDITION is set correctly.
HIGH ALTITUDE MODE
Switch to HIGH ALTITUDE MODE "ON" if over 1400m
(4593Ft).
MENU SELECT
SET
ENTER
INITIAL SETTING
COOLING CONDITION
It may shorten the life of the lamp and projector if used
in incorrect setting.
CHANGE
SET
ENTER
FRONT/FLOOR
OFF
CHANGE
AUTO
ENGLISH - 25
Advertisement
Table of Contents
