Installation (continued)
Adjusting the feet
The four adjustable feet (p. 14) mounted at the bottom of the projector are level-adjustable (0 mm–15 mm) which
can be used when the mounting surface is uneven.
Projection scheme
All four combinations of Front, Rear, Ceiling or Floor mounting are available. Use the INSTALLATION menu to
choose the desired projection scheme. (p. 78)
Installation geometry
When planning the projector and screen geometry, refer to the figures below and the information on the next page
for reference. After the projector is roughly positioned, picture size and vertical picture positioning can be finely
adjusted with the powered zoom lens and lens shifting mechanism.
When attaching an optional ceiling mount bracket (ET-PKD100H)
Side View
H
H
Screen
L
Projection distance
SH
Height of the image
SW Image width
Vertical distance between the lens center level and
H
the bottom edge of the projected image
* For PT-D12000U:
For PT-DZ12000U:
* However, if the ET-D75LE5 has been installed,
the value will be fixed at H=SH/2 for both the
PT-D12000U and PT-DZ12000U. If the ET-D75LE6
has been installed, the values will be H = 0.1 × SH
to 0.9 × SH for the PT-D12000U, and H = 0 to SH
for the PT-DZ12000U.
20 – ENGLISH
(Front)
(unit : mm/inch)
L
254
(10˝)
L
H = 0 to SH
H = -0.1 × SH to 1.1 × SH
(Rear)
Top View
L
Screen
Lens
ET-D75LE1
ET-D75LE2
ET-D75LE3
ET-D75LE4
ET-D75LE5
ET-D75LE6
ET-D75LE8
(unit : mm/inch)
200
(7.9˝)
L1
175
(6.9˝)
254
(10˝)
Lens Protrusion L1
(Approx.)
62.5 (2.5˝)
47 (1.9˝)
50.5 (2˝)
74.4 (2.9˝)
150.5 (5.9˝)
160 (6.3˝)
202.5 (8˝)