Using The Remote 2 Terminal - Panasonic PT-D12000U Operating Instructions Manual

Using the Remote 2 terminal

Using the REMOTE 2 terminal provided on the connection terminals of the main unit, it is possible to operate the
projector from a control panel etc. furnished in a distant location where infrared remote control signal cannot be
received.
Example of a control panel layout
Projector set up in a meeting room
Pin assignments and control
Be sure to short-circuit Pins 1 and 9 when controlling.
D-Sub 9-pin (female)
external appearance
Note
• The above figure shows the pin assignment and control details when "REMOTE2 MODE" (p. 80) is "DEFAULT".
When using "REMOTE2 MODE" with "USER", the pin assignment and control details are those set for "USER".
1 and pin 9 are short-circuited, the following buttons on the projector's control panel and on the
• When pin
remote control cannot be used.
POWER button, SHUTTER button
In addition, the RS-232C commands and network functions that correspond to these functions cannot be used
either.
1 and pin 9 are short-circuited and then any one of pins 3 to 7 is short-circuited to pin 1 , the
• When pin
following buttons on the projector's control panel and on the remote control cannot be used.
POWER button, input selection buttons (RGB1, RGB2, DVI-D, AUX, VIDEO, S-VIDEO), SHUTTER button
In addition, the RS-232C commands and network functions that correspond to these functions cannot be used
either.
110 – ENGLISH
Names of terminals
1
GND
2
POWER
3
RGB1
4
RGB2
5
VIDEO
6
S-VIDEO
7
DVI-D
8
SHUTTER
9
RST / SET
Remote terminal
Remote terminal/External control
STANDBY
RGB1
RGB2
DVI-D
Control panel located in a different room
Open (H) Short (L)
GND
OFF ON
Other RGB1
Other RGB2
Other VIDEO
Other S-VIDEO
Other DVI-D
OFF ON
Controlled by Controlled by
remote control external contact
External control
ON
LAMP
VIDEO
S-VIDEO