Initial Setting (Installation Setting); Initial Setting (Stand By Mode) - Panasonic PT-DZ870U Operating Instructions Manual

Initial setting (installation setting)

Set [PROJECTION METHOD] and [COOLING CONDITION] depending on the installation mode. Refer to "Installation mode" (x page 32)
for details.
Set [HIGH ALTITUDE MODE] to [ON] when using the projector at high altitudes between 1 400 m (4 593') or higher and lower than 2 700 m
(8 858') above sea level.
After completed the initial setting, you can change the settings of each item from the [PROJECTOR SETUP] menu.
1) Press as to select an item.
2) Press qw to switch the setting.
3) Press the <ENTER> button to proceed to the initial setting.

Initial setting (stand by mode)

Set the operation mode during the standby. The default setting is [ECO] that keeps power consumption low during standby. When the network
function is used during standby, set to [NORMAL]. After completed the initial setting, you can change the settings of each item from the
[PROJECTOR SETUP] menu → [STANDBY MODE].
1) Press as to select an item.
2) Press qw to switch the setting.
3) Press the <ENTER> button to proceed to the initial setting.
Chapter 1 Preparation — Start-up display
INITIAL SETTING
PROJECTION METHOD
When PROJECTION METHOD is changed, confirm that
COOLING CONDITION is set correctly.
COOLING CONDITION
It may shorten the life of the lamp and projector if used
in incorrect setting.
HIGH ALTITUDE MODE
Switch to HIGH ALTITUDE MODE "ON" if over 1400m
(4593Ft).
MENU SELECT
SET
ENTER
INITIAL SETTING
STANDBY MODE
When set to ECO, network functions and SERIAL OUT
terminal, and some RS-232C commands are not
available during standby.
CHANGE
SET
ENTER
2/4
FRONT/FLOOR
AUTO
OFF
CHANGE
3/4
ECO
ENGLISH - 23