Connection - Panasonic PT-D12000U Operating Instructions Manual

Connection

Before starting connection
• Before connection, read carefully the instruction manual for the device to be connected.
• Turning off the power switch of the devices before connecting cables.
• If any connection cable is not supplied with the device, or if no optional cable is available for connection of the
device, prepare a necessary system connection cable to suit the device.
• Video signals containing too much jitter may cause the images on the screen to randomly wobble or wafture. In
this case, a time base corrector (TBC) must be connected.
• The projector accepts the following signals: video, S-Video, analog RGB, DVI-D and signals which are
compatible with the optional input module (p. 30).
• Some PC models cannot be connected to the projector.
The pin-out and signal names of the S-VIDEO IN terminal are shown in the diagram below.
Outside view
The pin-out and signal names of the RGB2 IN terminal are shown in the diagram below.
Outside view
4 , 9 , l ,and o are not assigned.
5 - 8 , j and k are GND terminals.
The pin-out and signal names of the DVI-D IN terminal are shown in the diagram below.
x
p
8
Outside view
Pin No.
1
2
3
4
Pin No.
1
2
3
m
n
Pin No.
q
1
T.M.D.S data 2–
2
T.M.D.S data 2+
9
3
T.M.D.S data 2 / 4 shield
1
4
5
6
DDC clock
7
DDC data
8
9
T.M.D.S data 1–
j
T.M.D.S data 1+
k
T.M.D.S data 1 / 3 shield
l
Ground (luminance signal)
Ground (color signal)
Luminance signal
Color signal
R/P
R
G/G • SYNC/Y
B/P
B
HD/SYNC
VD
Signal
Signal
Signal
Pin No. Signal
m
n
+5V
o
Ground
p
Hot plug detection
q
T.M.D.S data 0-
r
T.M.D.S data 0+
s
T.M.D.S data 0 / 5 shield
t
u
v
T.M.D.S clock shield
w
T.M.D.S clock+
x
T.M.D.S clock–
ENGLISH – 27