Projection - Panasonic PT-D12000U Operating Instructions Manual

Projection

Power indicator lamp
This shows the power supply status. Make sure
that you fully understand the operation of the power
indicator lamp before operating the projector.
Indicator
status
Off Main power is off
Standby mode
Red Lit POWER ON ( | ) button can be pressed
so that images can be projected.
Green Lit Images are being projected (on)
Cooling mode
Orange Lit After a short while, the projector will
switch to standby mode.
Attention
• While the projector is in cooling mode (when the
power indicator lamp is lit orange), the internal fan
is running to cool down the projector. Do not turn
off the MAIN POWER switch or disconnect the
power cord at this time.
Note
• If the POWER ON " | " button is pressed while
the projector is still in cooling mode, it may take
some time before the projector is ready to project
pictures.
Power indicator lamp
OPEN
FILTER
CLEANING
CLOSE
Projector status
Lock Button
Connecting the power
cord
Insert the accessory power cord securely into the
projector and the electrical outlet.
Be sure to read the "IMPORTANT SAFETY NOTICE"
(pp. 4-5) and "Precautions with regard to safety"
(pp. 6-9) for details on handling the power cord.
Installation
1. Check the shape of the AC
IN terminal on the side of the
projector and the shape of the
power cord connector, and insert
the power cord securely into the
AC IN terminal.
2. Insert the power cord plug into
an electrical outlet.
Removal
1. Check that the MAIN POWER
switch on the projector is at
the OFF "○" position, and then
disconnect the power cord plug
from the electrical outlet.
2. Remove the power cord from the
AC IN terminal while pressing
the lock button on the power
cord connector.
Attention
• Connect all peripheral equipment to the projector
before connecting the projector's power cord.
(pp. 28-29)
ENGLISH – 37