Gamma Setting - Panasonic PT-D12000U Operating Instructions Manual

Adjusting the picture (continued)
Press ◄► to switch "COLOR
3.
TEMPERATURE".
• The setting will change as follows each time
◄► is pressed.
DEFAULT
HIGH
• When any setting other than "OFF" has been
selected for color matching, the COLOR
TEMPERATURE setting is fixed at "USER1".
• "DEFAULT" cannot be selected when the picture
mode has been set to "USER".
To further adjust toward the
desired white balance
4. Select "USER1" or "USER2" in
Step 3.
5. Press ENTER.
• The "WHITE BALANCE" screen will be
displayed.
WHITE BALANCE
WHITE BALANCE HIGH
WHITE BALANCE LOW
Press ▲▼ to select "WHITE
6.
BALANCE HIGH" or "WHITE
BALANCE LOW".
7. Press ENTER.
• The "WHITE BALANCE HIGH" RGB settings
are used to set the projector's white point color
temperature. The "WHITE BALANCE LOW"
RGB settings are used to adjust the color
temperature of the black levels.
WHITE BALANCE HIGH
RED
GREEN
Press ▲▼ to select "RED",
8.
"GREEN" or "BLUE".
Press ◄► to adjust the level.
9.
Item Operation
Press ►
button.
RED
Press ◄
button.
Press ►
button.
GREEN
Press ◄
button.
Press ►
button.
BLUE
Press ◄
button.
56 – ENGLISH
USER1 USER2
MIDDLE LOW
255
255
Adjustment
Adjustment
range
Maximum
Deepens red.
value
HIGH : 255
Weakens red.
LOW : 127
Deepens green.
Minimum
value
HIGH : 0
Weakens green.
LOW : -127
Deepens blue.
Default
HIGH : 255
Weakens blue.
LOW : 0
Note
• All colors will not be displayed properly unless
adequate adjustment is made. If the adjustment
does not look suitable, you can press DEFAULT to
return the setting for the selected item only to the
factory default setting.
• The color temperature cannot be adjusted for the
internal test pattern (p. 87). Be sure to project the
input signal when adjusting the color temperature.

Gamma setting

This switches the gamma mode.
Press ▲▼ to select "GAMMA".
1.
COLOR TEMPERATURE
GAMMA
SYSTEM DAYLIGHT VIEW
Press ◄► or ENTER.
2.
• The "GAMMA" individual adjustment screen
will be displayed.
GAMMA
CHANGE
Press ◄► to switch "GAMMA".
3.
• The setting will change as follows each time
◄► is pressed.
DEFAULT USER1*
2.6
* "USER1" and "USER2" can hold user-defined
gamma curves uploaded to the projector through
the RS-232 terminal.
Additional Gamma settings can be made available
for selection from a sub-menu.
Consult your dealer for more information.
Note
• "DEFAULT" cannot be selected when the picture
mode has been set to "USER".
System daylight view setting
This corrects images so that they appear vivid when
projected under bright lighting.
Press ▲▼ to select "SYSTEM
1.
DAYLIGHT VIEW".
GAMMA
SYSTEM DAYLIGHT VIEW
SHARPNESS
Press ◄► or ENTER.
2.
• The "SYSTEM DAYLIGHT VIEW" individual
adjustment screen will be displayed.
SYSTEM DAYLIGHT VIEW
CHANGE
DEFAULT
DEFAULT
OFF
DEFAULT
USER2*
2.5 2.2
DEFAULT
OFF
0
OFF